HP P3410A - NetRAID 1M RAID Controller Installation And Configuration Manual page 153

Chapter 14
Can't unload raidserv.nlm
If the adapter in a NetWare server is being accessed by a configuration utility
(HP NetRAID Assistant in Full Access mode or HP NetRAID Config), the
raidserv.nlm module cannot be unloaded until the adapter is no longer being
accessed. This prevents a critical operation in the adapter, such as a disk rebuild,
from being interrupted.
HP NetRAID Assistant does not list any servers when started (other than "local")
When HP NetRAID Assistant starts, the Main Screen only lists
"<clientname>(Local)" in the pull-down list of servers. The Registration Server
may be down, or no servers may have checked in with it.
Be sure that the Registration Server is working and that it started before the other
servers. Servers can only log into the Registration Server when the access server
(Windows NT or Windows 2000) or raidserv.nlm (NetWare) executes.
Troubleshooting
145