Upgrading To An Hp Netraid-1M Or Hp Netraid-2M Adapter - HP P3410A - NetRAID 1M RAID Controller Installation And Configuration Manual

8 Upgrading to an HP NetRAID-1M or
HP NetRAID-2M Adapter
This chapter explains how to replace an existing HP NetRAID adapter with an
HP NetRAID-1M or HP NetRAID-2M adapter. When you replace one adapter
with another, you must consider data compatibility. Data created using one
HP NetRAID adapter is not necessarily compatible with any other HP NetRAID
adapter.
NOTE
To replace an HP NetRAID-1M or NetRAID-2M adapter, you need to:
1. Back up your data.
2. Load the appropriate driver.
3. Insert the HP NetRAID-1M or HP NetRAID-2M adapter and restore your
RAID settings.
CAUTION
4. Restore your data from backup.
A new adapter must have channels that are equal in number or
greater than the adapter it is replacing. Do not replace an
HP NetRAID-3si adapter (using three channels) with a
NetRAID-1M or NetRAID-2M adapter (which can control
only one or two channels).
Do not insert an HP NetRAID-1M or 2M adapter with the
Netserver powered on. Unplug the HP Netserver power
cord(s) before installing a HP NetRAID-1M or 2M board.
99