Replace Cover; Step F. Start Hp Netserver Navigator To Launch Hp Netraid Assistant; Boot Hp Netserver Navigator Cd-Rom; Boot Messages - HP P3410A - NetRAID 1M RAID Controller Installation And Configuration Manual

Chapter 5
CAUTION Handle disk modules carefully. They are more susceptible to
shock, vibration, and electrostatic discharge when they are
not in the cabinet. When removing a module while the system
is powered on, disengage the module and wait for it to stop
spinning before removing it from its hot-swap slot.
Also, do not touch the SCSI edge connector pins. The oils on
your skin could impair the electrical connection.

Replace Cover

If you removed the power supplies or fans, replace them according to the
instructions in your HP Netserver documentation.
Close or replace the panels or covers on the computer and reconnect the
HP Netserver to power and networks.
Step F. Start HP Netserver Navigator to Launch
HP NetRAID Assistant

Boot HP Netserver Navigator CD-ROM

To launch the HP NetRAID Assistant, you must start from the HP Netserver
Navigator CD-ROM. Ensure that all the SCSI devices power up before or at the
same time as the host computer.
NOTE
HP NetRAID-1M and 2M adapters do not support bootable
CD-ROM drives or tape drives.

Boot Messages

If you receive an error message during the boot process, refer to Chapter 14,
"Troubleshooting," or to the online help in Information Assistant for more
information. Some power-up (boot) messages are routine.

Select Disk Array Controller Configuration

If HP Navigator asks you to set the date, time, and so on, do so. The
HP Netserver Navigator Main Menu then appears.
1. When the HP Netserver Navigator Main Menu is displayed, choose
Configure the Server.
2. Choose Custom Setup from the next group of choices.
46
Installation and Configuration