Tools You May Need - HP P3410A - NetRAID 1M RAID Controller Installation And Configuration Manual

Chapter 1
Technical Reference Cards or labels on the HP Netserver system chassis
(for cables and SCSI ID switch settings)
Internet site: http://netserver.hp.com/netserver/

Tools You May Need

Please refer to your HP Netserver documentation for the tools needed to open the
chassis. Usually a flat 1/4-inch screwdriver and a T15 Torx driver are required. If
you need to set SCSI ID switches, a flashlight and a small metal pin, such as a
straightened paper clip, will be helpful. An antistatic kit (3M 8501/8502/8505 or
equivalent) is strongly recommended.
CAUTION
All HP NetRAID adapter cards are sensitive to static
electricity and can easily be damaged by improper handling.
Using a grounding strap is recommended. Read the following
information carefully before you handle the accessory:
Leave the adapter card in the antistatic bag until you are
ready to install it.
If possible, use an antistatic wrist strap and grounding
mat.
Before you remove the adapter board from the bag, touch a
grounded, unpainted metal surface on the system to
discharge static electricity.
Introduction
9