Table of Contents
Advertisement
Specifications
HP NC112T PCI Express Gigabit Server Adapter
specifications
Specification
Network Controller Chipsets Intel® 82574L
Bus Type
Bus Width
On-board Memory
Data Transfer Method
Boot ROM Support
Management Capabilities
Power Requirement
Data Transmission Rate
Standards Supported
Dimensions
Connector and Distances
Interrupts Supported
Temperature Range
Relative Humidity (non-
condensing)
Safety Compliance
UTP cable specifications
The NC112T adapter can use existing UTP CAT5 (or better) cable to deliver Gigabit Ethernet over
copper, according to the IEEE 802.3ab specifications. For new installations, CAT5e (enhanced CAT5)
cable is recommended.
Value
x1 PCI Express v1.1 (2.5 GTps)
One lane (x1)
32 KB
Bus Master DMA
Yes
WOL, PXE 2.2, ACPI 1.0 (Note: WOL and PXE are set to the default of off)
575 mA @ 3.3 VDC max
10 Full/10 Half, 100 Full/100 Half, 1000 Full
IEEE 802.3u, IEEE 802.3x (flow control), IEEE 802.3ad (link aggregation), IEEE
802.1p (QoS), IEEE 802.1q (VLAN tagging), IEEE802.3z, IEEE802.3ap,
IEEE802.3ae
11.93 cm x 5.58 cm [4.7 in x 2.2 in (L x W)] (without bracket)
10BASE-T: Category 3, 4, or 5 UTP 100 M (328 ft)
100BASE-TX: CAT5 UTP 100 M (328 ft)
1000BASE-TX: CAT5 UTP 100 M (328 ft)
Automatically configured
Operating: 0°C to 55°C (32°F to 131°F)
Storage: -40°C to 85°C (-40°F to 185°F)
Operating: 10% to 95%
Storage: -5% to 95%
UL Mark (US and Canada)
CE Mark
EN60950
RoHS (European Union)
Specifications 11
Advertisement
Table of Contents
