Using Hp Netraid Assistant To Manage Servers; Before Starting Hp Netraid Assistant - HP P3410A - NetRAID 1M RAID Controller Installation And Configuration Manual

Chapter 9
7. Enter and retype the password that will be required for access to this
server. Passwords are case-sensitive.
8. Verify that the regserv.dat file located at
sys:\etc\regserv.dat contains the name of the system that will be
the Registration Server for this network.
9. Edit the hosts file located at sys:\etc\hosts . It should contain the
IP address and name of each server with integrated HP NetRAID
controllers (or HP NetRAID-1M or 2M adapters) to be managed over the
network.
10. Restart NetWare.
NOTE

Using HP NetRAID Assistant to Manage Servers

Before Starting HP NetRAID Assistant

The Registration Server must be running before any other servers are started.
If the Registration Server is a NetWare server, it must be running
reg_serv.nlm .
If the Registration Server is a Windows NT or Windows 2000 server, it
must be running the HP NetRAID Registration Server icon (under the
HP NetRAID program group).
To access an HP NetRAID-1M or 2M adapter in a server from the network, the
three services listed below must be running. Start them in the order listed. You
may set them for automatic start, if desired.
1. NobleNet Portmapper: It should have been installed by the HP NetRAID
software and set for automatic start in Windows NT or Windows 2000. In
NetWare 4.x, load rpcstart.nlm . In NetWare 5.x, it is not needed
because sockets are used instead.
118
Managing Servers Over the Network
If the NetWare server is a Registration Server, the
reg_serv.nlm will be put in autoexec.ncf to
automatically start it. However, if the software was
installed previously, but not as a Registration Server,
edit the autoexec.ncf file to add the statement
load reg_serv.nlm so that the Registration Server
will automatically start under NetWare.