Hard Drive Migration Between Controllers; Forward Migration - HP P3410A - NetRAID 1M RAID Controller Installation And Configuration Manual

Chapter 8
11. After scanning has finished, press ESC.
12. You will get a warning that you cannot undo a migration. Choose Yes to
migrate the configuration. The HP NetRAID Express Tools utility now
updates the configuration stored in NVRAM on the newly installed
adapter.
13. Press ESC repeatedly to exit HP NetRAID Express Tools.
14. Press CTRL+ALT+DELETE to restart the system. The new adapter
should recognize all the drives and the previous logical configuration.

Hard Drive Migration Between Controllers

Previous generations of HP NetRAID adapters—NetRAID, NetRAID-1, NetRAID-3Si,
NetRAID-1Si, integrated HP NetRAID (LH 3/LH 4), and integrated HP NetRAID
(LH 3000/LH 6000/LT 6000r)—supported a maximum of eight logical drives. The HP
NetRAID-1M and 2M can support up to 40 logical drives. This enhancement affects the
ability to keep the RAID configuration intact when moving the hard disks from the
previous generation of adapters to the HP NetRAID-1M or 2M.

Forward Migration

Forward migration of the hard drives from the previous generation to the new
generation of adapters is supported.
NOTE
HP NetRAID-1M or 2M adapter will support RAID 3 and 30
configurations when they are migrated from an older
controller. You cannot, however, configure new RAID 3 or 30
configurations on an HP NetRAID 1M or 2M adapter.
104
Upgrading to an HP NetRAID-1M or HP NetRAID-2M Adapter