HP P3410A - NetRAID 1M RAID Controller Installation And Configuration Manual page 100

Chapter 7
I. Enable Virtual Sizing
NOTE
Clearing a previous configuration does not reset the virtual
sizing setting for a logical drive. Use the Reset to Factory
Defaults option in HP NetRAID Express Tools to disable
virtual sizing for all logical drives, or manually change the
setting as described below.
1. Restart the host HP Netserver, and watch for the message:
Option: Experienced users may press <Ctrl> <M> for
HP NetRAID Express Tools now.
Firmware Initializing
2. When the message is displayed, press <Ctrl> <M>. When the system
stops scanning, HP NetRAID Express Tools starts and displays the Tools
Management menu.
3. If there is more than one HP NetRAID-1M or 2M adapter installed
(including any integrated HP NetRAID controller), do the following to
select the integrated controller or adapter controlling a logical drive you
want to prepare for expansion:
a. Choose Adapter from the Tools Management menu.
b. Choose the adapter controlling the logical drive.
4. Choose Objects from the Tools Management menu.
5. Choose Logical Drive from the Objects menu.
6. From the Logical Drive menu, choose the logical drive you want to
prepare for expansion.
7. From the Logical Drive menu for the drive you want to prepare, choose
Properties.
8. Choose Virtual Sizing.
9. On the Virtual Size menu, choose Enable, and confirm your choice.
10. Press Esc twice to return to the Logical Drive menu.
If you need to enable virtual sizing on another logical drive, choose the
logical drive and repeat steps 6 through 10.
92
Preparing for Online Capacity Expansion