HP P3410A - NetRAID 1M RAID Controller Installation And Configuration Manual page 145

Chapter 14
3. Use View/Add/Delete Configuration to examine both configurations.
4. Resolve the configuration mismatch by selecting and saving one of the
two configurations.
Configuration of NVRAM and drives mismatch for Host Adapter – x (Normal
Mismatch).
Run View/Add/Delete Configuration option of Configuration Utility.
Press any key to enter the Configuration Utility.
Problem: You have installed more than one adapter, and the configuration stored
in NVRAM of adapter x does not match the configuration stored in the drives.
All drives on that adapter contain one set of configuration information, and
NVRAM contains a different set.
Suggested solution:
1. Press any key to enter HP NetRAID Express Tools.
2. From the Configure menu, choose the View/Add/Delete Configuration
option. View/Add/Delete Configuration asks which configuration you
want to view: NVRAM or disk.
3. Use View/Add/Delete Configuration to examine both configurations.
4. Resolve the configuration mismatch by selecting and saving one of the
two configurations.
Configuration of NVRAM and drives mismatch (Legacy Array Found)
Run View/Add/Delete Configuration option of Configuration Utility.
Press any key to enter the Configuration Utility.
Problem: There is a single adapter, and the configuration stored in the drives is
from a legacy controller (1Si or 3Si). All drives contain one set of configuration
information, and NVRAM contains a different set.
Suggested solution: Do the following to migrate the configuration from the
legacy controller to the newer 1M or 2M controller.
1. Press any key to enter HP NetRAID Express Tools.
2. From the Configure menu, choose the View/Add/Delete Configuration
option. The View/Add/Delete Configuration option asks which
configuration you want to view: NVRAM or disk. Choose disk. Select
Yes to migrate the configuration.
Troubleshooting
137