Installing A Non-Hot Plug Pci Board - HP Integrity rx4610 User Manual

Chapter 7
12. Close the plastic latching mechanism that secures the end of the board
nearest the front of the chassis.
13. Rotate the PHP mechanism near the rear of the chassis up until it clicks
into place. This position both secures the end of the board and allows it to
be activated with the operating system or GUI application.
14. Close the rear part of the top cover and tighten the two thumbscrews.
15. Connect any required cabling to the add-in board.
16. If your server is operating, use the operating system or GUI application to
power up the PCI I/O slot into which you installed the PCI I/O board.
17. Push the system back into the equipment rack.

Installing a Non-Hot Plug PCI Board

Use this procedure to install a non-hot plug PCI accessory board. Observe the
safety guidelines listed earlier. The server must be shut down before installing a
non-hot plug PCI board.
1. If the HP Server is already installed and working, power down the HP
Server.
Refer to Chapter 1, "Controls, Ports, and Indicators."
WARNING
The power supply will continue to provide standby current to
the HP Server until the power cable is disconnected.
2. Disconnect the power cables and any external cables connected to the HP
Server. If necessary, label each one to expedite re-assembly.
WARNING
Make sure that the rack is anchored securely, so it will not tip
when the server chassis is extended.
3. Pull the chassis out of the rack.
CAUTION
Wear a wrist-strap and use a static-dissipating work surface
connected to the chassis when handling components. Ensure
the metal of the wrist-strap contacts your skin.
4. Loosen the two thumbscrews in the back of the chassis that secure the rear
cover.
Refer to Chapter 2, "Opening and Closing the HP Server."
74
Installing Accessory Boards