HP Integrity rx4610 User Manual page 93

Chapter 8
Disconnect the external SCSI cable from I/O Baseboard
Figure 8-1. Removing the SCSI Cable from the I/O Baseboard
8. Loosen the captive screw to disconnect and remove the external SCSI port
from the chassis I/O connector at the rear of chassis.
9. Remove all non-hot plug PCI and hot plug PCI I/O adapter boards as
described in "Removing Accessory Boards" in Chapter 7.
10. Remove all PCI slot plastic dividers.
11. Loosen the thumbscrew at the back of the chassis holding the protective
cover over the DC-DC converters on the Sideplane, and remove the cover.
Server Management Boards
Remove protective
Sideplane cover
85