Non-Hot-Plug Pci Riser Board Slot Definitions - HP ProLiant DL385 G5p Maintenance And Service Manual

Item Description
NIC activity LED
4
iLO 2 link LED*
NIC link LED
5
iLO 2 activity LED* Green = Network activity
* iLO 2 LED positions are reversed from the embedded NIC LEDs

Non-hot-plug PCI riser board slot definitions

Primary
(slot - form factor)
1 - FL/FH
2 - HL/FH
3 - HL/FH
Notes:
•
"Primary" denotes the risers are installed in the primary riser connector.
•
"Secondary" denotes the risers are installed in the secondary riser connector.
•
FL/FH denotes full-length, full-height. HL/FH denotes half-length, full-height. LP denotes low profile.
•
The PCIe x16 riser supports a maximum power of 225W with an HP power cable. This cable must be
used for PCIe card wattages greater than 75W.
Status
Green = Network activity
Flashing green = Network activity
Off = No network activity
Green = Network link
Off = No network link
Green = Network link
Off = No network link
Flashing green = Network activity
Off = No network activity
Secondary PCIe riser
slot description
(slot - form factor)
4 - FL/FH PCIe x16 (8,4,1)
5 - LP PCIe x8 (4,1)
6 - LP PCIe x8 (4,1)
PCIe x16 riser PCIe/PCI-X riser
slot description slot description
PCIe x16 (16,8,4,1) PCI-X 64bit/133MHz
— PCIe x16 (8,4,1)
— PCIe x8 (4,1)
Component identification 72