HP Integrity rx4610 User Manual page 160

Chapter 10
The command-line options for the FRUSDR Load Utility are described in
Table 10-19 below. Each option can be preceded by either the forward slash
character (/) or the hyphen character (-).
Table 10-19. FRUSDR Load Utility Command-line Options and
Parameters
Option or Parameter
/? or /h
/d {FRU, SDR}
/Cfg filename.cfg
/p
The basic command line format is:
frusdr [/?] [/h] [/p] [/d { fru, sdr}] [/Cfg filename.cfg]
The /d FRU option displays FRU information from a particular address. These
addresses are used to view different FRU areas. The default display is the BMC
FRU. The parameters following the /d FRU are in the same order and value as the
NVS_TYPE, DEV_CNTR and DEV_ID that are found in the FRU file header.
Usage:
FRUSDR /D FRU [(NVS_TYPE) [DEV_CNTR] (DEV_ID)]
Example:
FRUSDR /D FRU IMBDEVICE CCO 01
FRUSDR /D FRU IMBDEVICE C20 0D
FRUSDR /D FRU IMBDEVICE 10
FRUSDR /D FRU
The configuration file may be used to load multiple FRU and SDR files. In the
configuration file, each FRU and SDR file name must be called out. Additionally,
each FRU area and field to be programmed must also be specified. The
configuration file may be used to prompt or request information from the user, and
to inquire from the user which FRU areas to program.
The pause command may be used with all other commands. It will cause the data
being displayed on the screen to pause after a pre-determined amount is written.
In some cases, if there isn't enough data being displayed to warrant a pause, then
the pause command will be ignored.
152
Configuring the HP Server
Description
Displays usage information.
Displays the requested area.
Uses a custom configuration file to drive the
FRUSDR Load Utility.
Pause output between blocks of data.
{for Hot-Swap Back Plane}
{for Processor Board}
{for I/O BaseBoard
{for BMC (Legacy Board)}