Sideplane Board; Removing The Sideplane Board - HP Integrity rx4610 User Manual

Chapter 8

Sideplane Board

The Sideplane is attached inside the left wall at the rear of the chassis. It receives
the I/O Baseboard as well as the Power Distribution Board (T-Docking). To
remove the Sideplane you must remove the Power Distribution Board (T-
Docking), the I/O Baseboard, and the Processor/Memory Complex.

Removing the Sideplane Board

To remove the Sideplane board, complete the following procedure:
1. Observe all safety and ESD precautions for handling electronic
components.
2. Remove the I/O Baseboard as described in "Removing the I/O Baseboard"
in this chapter.
3. Remove the Power Distribution Board (T-Docking) as described in
"Removing the Power Distribution Board (T-Docking)" in this chapter.
4. Remove the Processor/Memory Complex as described in "Removing the
Processor/Memory Complex" in Chapter 5.
a) Remove the sheet-metal cover protecting the D2D converts on the
sideplane board.
b) Remove the D2D converters from the sideplane board.
NOTE Do not remove the screws that hold the Sideplane to the
mounting plate.
5. Loosen the captive thumbscrews on the Sideplane that secure it and its
mounting plate to the chassis.
Server Management Boards
89