Removing And Installing A Memory Board (Non-Hot-Plug) - HP ProLiant DL580 User Manual

Close the ejector lever, and lock the locking switch.
7.
NOTE:
rebuilding.
Configure the memory
8.
Reference the memory board LEDs
9.
that the memory board is functioning properly.

Removing and installing a memory board (non-hot-plug)

Power down the server (on page 24).
1.
Unlock the locking switch, and open the release latch.
2.
Use the ejector lever to pull the memory board out of the server.
3.
The board status LED might flash green for several minutes while the board is
("Configuring the
("Memory board components and
memory" on page 78), if applicable.
LEDs" on page 9) to be sure
Memory options 76