Removing And Installing The Scsi Backplane; Removing The Scsi Backplane - HP Integrity rx4610 User Manual

Chapter 4

Removing and Installing the SCSI Backplane

The SCSI Backplane resides on the back of the Hard Drive Bay. It is accessed by
removing the Hard Disk Bay.

Removing the SCSI Backplane

To remove the SCSI Backplane, complete the following steps:
1. Remove the Hard Disk Bay as described in "Removing the Hard Disk
Bay" earlier in this chapter.
2. Disconnect the LCD panel cable from the SCSI Backplane.
3. Remove the cap stabilizer retaining screw and the cap stabilizer. These
two items will be used on the new board.
4. Remove the three screws that secure the SCSI Backplane to the Hard Disk
Bay.
5. Carefully place the SCSI Backplane on a clean, anti-static work surface or
in anti-static packaging.
Figure 4-6. Removing the SCSI Backplane
38
Installing Mass Storage Devices