Installing Non-Hot Swap Drives; Installing The Floppy Disk Drive - HP Integrity rx4610 User Manual

Chapter 4
3. While grasping only the drive carrier handle, firmly push the assembly
into the bay until the drive docks with the backplane connector and the
carrier latch locks.
4. Replace the plastic bezel on the front of the server.

Installing Non-Hot Swap Drives

The HP Server supports a slimline IDE diskette drive for 1.44 MB and 120 MB
media and a DVD drive. Both drives are part of the standard configuration and
mount directly above the power bays on the front of the chassis. The drives are
mounted on removable trays that facilitate system assembly and service. The
server must be powered down to install these drives.

Installing the Floppy Disk Drive

The floppy disk drive is housed in a two-piece drive carrier assembly that rests on
the chassis surface. The assembly is accessible when the top cover is removed.
The following procedures describe how to remove and install the drive.
32
Figure 4-2 Hot Swapping a SCSI Drive
Installing Mass Storage Devices