HP Integrity rx4610 User Manual page 231

Appendix A
Clearing the CMOS Register
Jumper block J7A1 controls whether settings stored in CMOS nonvolatile
memory (NVRAM) are retained during a system reset. By default, the system
does not keep the default values in this register. You can configure J7A1 to
restore the system defaults.
Figure A-18. CMOS Register Clear Jumper
Jumper settings labeled:
A. Do Not Keep Default Values in the CMOS Register (Default Setting)
B. Clear the CMOS Register and Restore the System Default Values
Clearing System Password
Jumper block J7A1 controls whether a stored password is retained or cleared
during a system reset. By default, the system retains this password. To clear it
you must configure jumper block J7A1.
J7A1 J7A1
1 1
A B
J7A1 J7A1
1 1
A B
Figure A-19. Password Clear Jumper
Specifications
223