HP Integrity rx4610 User Manual page 54

Chapter 5
4. Loosen the two captive screws holding the sides of the memory board to
the processor board. Each of these screws secures a board clamp that runs
along the length of the memory board.
5. Lift the board clamps out of the Processor/Memory Complex.
6. Loosen the two captive screws in the handle that spans the middle of the
Memory Board.
7. Remove the bracket with the thumbscrew that locks the extraction levers.
8. Pull up on the extraction levers to disengage the memory board from the
processor board.
NOTE Both extraction levers must be raised evenly while disengaging
the memory from the Processor Baseboard. The memory board
must remain parallel to the Processor Baseboard during
extraction.
9. Place the memory board on a clean ESD-protected surface.
46
Installing Additional Memory