Installing The Front Panel Board - HP Integrity rx4610 User Manual
Hp server rx4610 user guide
Hide thumbs
Also See for Integrity rx4610:
- User manual (201 pages) ,
- Service manual (147 pages) ,
- Installation manual (16 pages)
Table of Contents
Advertisement
Chapter 4
2. Remove the two screws.
Installing the Front Panel Board
To install the new Front Panel Board, complete the following steps:
1. Using two Phillips screws, secure the new Front Panel Board to the Hard
Disk Bay.
2. Connect the front part of the Front Panel Board data cable to the connector
on the new Front Panel Board.
3. Install the Hard Disk Bay into the chassis as described in "Installing the
Hard Disk Bay" above.
40
Figure 4-7. The Front Panel Board
Installing Mass Storage Devices
1. Disconnect the cable.
Advertisement
Table of Contents
Troubleshooting
