HP Integrity rx4610 User Manual page 104

Chapter 8
2. Be sure that the plastic retaining mechanism (I/O Card Guide) that secures
the end of the board nearest the front of the chassis is open so that it will
allow a board to be inserted.
NOTE Being careful not to touch the components or gold edge
connectors on the I/O Legacy board, remove it from its
protective wrapper, and place it component-side up on a
nonconductive, antistatic surface within reach of the primary
and secondary IDE cables in the server.
3. Record the serial number of the board in your equipment log.
4. Connect the primary and secondary IDE cables to their respective
connectors on the I/O Legacy board.
5. Connect the server management cable to the Legacy I/O board.
6. Press the board down firmly until it seats in its slot.
7. Attach the rear screw that secures the board to the chassis.
8. Close the plastic latching mechanism that secures the end of the board
nearest the front of the chassis.
9. Install the non-hot plug PCI adapter board cover by aligning the slotted
hinge into the chassis housing, closing the cover, and securing the cover
screw.
10. Close the rear part of the top cover and secure it by tightening the two
thumbscrews in the back.
11. Attach any peripherals to the rear panel of the Legacy I/O board.
12. Install the power cords to the system.
13. Push the system into the equipment rack.
14. Power-on the system.
15. Turn on all peripheral devices connected to the system that you shut down
during this procedure.
96
Server Management Boards