Configuring Ethernet Interfaces
This example shows how to delete the interface-range macro enet_list and to verify that it was deleted.
Switch# configure terminal
Switch(config)# no define interface-range enet_list
Switch(config)# end
Switch# show run | include define
Switch#
Configuring Ethernet Interfaces
These sections contain this configuration information:
•
•
•
•
•
•
•
•
•
Default Ethernet Interface Configuration
Table 12-2
listed in the table, see
see
Feature
Allowed VLAN range
Default VLAN (for access ports)
Native VLAN (for IEEE 802.1Q
trunks)
VLAN trunking
Port enable state
Port description
Speed
Duplex mode
Flow control
EtherChannel (PAgP)
Catalyst 2975 Switch Software Configuration Guide
12-16
Default Ethernet Interface Configuration, page 12-16
shows the Ethernet interface default configuration. For more details on the VLAN parameters
Chapter 13, "Configuring VLANs."
Chapter 23, "Configuring Port-Based Traffic Control."
Default Layer 2 Ethernet Interface Configuration
Chapter 12
For details on controlling traffic to the port,
Default Setting
VLANs 1 to 4094.
VLAN 1.
VLAN 1.
Switchport mode dynamic auto (supports DTP).
All ports are enabled.
None defined.
Autonegotiate.
Autonegotiate.
Flow control is set to receive: off. It is always off for sent packets.
Disabled on all Ethernet ports.
EtherChannels and Link-State Tracking."
Configuring Interface Characteristics
Chapter 37, "Configuring
OL-19720-02