Overall Steps; Printing With Tcp/Ip; Printing Method - Epson C823642 - Enet Print Server Type B Multi Protocol 10/100BTX Administrator's Manual

Overall steps

Follow these steps to use the Ethernet card with Windows 95 and
Windows 98. Go to the indicated chapters for more information.
1. Install TCP/IP components, if necessary. See Chapter 3.
2. Install NetBEUI components, if necessary. See this chapter.
Note:
If you use the Ethernet card with TCP/IP, you need to make sure TCP/
IP is installed. If you use the Ethernet card with NetBEUI, you also
need TCP/IP, which allows you to access the card's home page.
3. If you are not on a peer-to-peer network, install EPSON Net!2 for
Windows. See Chapter 2.
4. Assign an IP address to the Ethernet card using EPSON Net!2 or
the arp command. See Chapter 3.
5. Set up the printer. See this chapter.

Printing with TCP/IP

If you haven't installed TCP/IP on the workstations using the printer,
you need to install it as described on page 3-1.

Printing method

Because Windows 95 and Windows 98 do not support the LPR
printing protocol, you need EPSON Status Monitor 2 to print with
TCP/IP. See Chapter 11, "EPSON Status Monitor 2 (Windows only)"
for more information.
6-2 Using the Ethernet Card with Windows 95 and Windows 98