Chapter 3 Setting The Ip Address; Overview; Installing The Tcp/Ip Protocols In Your Pc - Epson C823642 - Enet Print Server Type B Multi Protocol 10/100BTX Administrator's Manual

Chapter 3
Setting the IP Address
To use the Ethernet card with TCP/IP, you first need to set its IP
address.

Overview

Follow these general steps to set the card's IP address. See the
indicated chapters for more information.
1. Install TCP/IP protocol on the operating systems, if necessary.
See the section below.
2. For Windows or Macintosh, install EPSON Net!2. See Chapter 2.
3. Set the IP address using either:
The arp command (see page 3-8)
EPSON Net!2 for Windows/Macintosh (see page 3-10)
Note:
EPSON Net!2 cannot be used for OS/2 or UNIX. When
setting the IP address for OS/2 or UNIX, use the arp command.
4. Set up the printer. See Chapters 6 through 9.

Installing the TCP/IP Protocols in Your PC

Before using the Ethernet card with TCP/IP, you must make sure that
the TCP/IP protocol is installed on your operating system. After it is
installed, you can use the computer to configure the Ethernet card for
use with TCP/IP.
Setting the IP Address 3-1