Using The Ethernet Card In Remote Printer Mode - Epson C823642 - Enet Print Server Type B Multi Protocol 10/100BTX Administrator's Manual

Primary file server name:
Select the server where you created the queue.
Password:
Type any new password up to 19 characters. The characters
you enter appear as " ". You can also leave this space blank.
Print server name:
Type any new name up to 47 characters. The default name is
shown below.
(Printer name) - (last 6 digits of the serial number)
for example: EPL-N2000-PRIFNW
Polling interval:
Set the polling time from 5 to 90 seconds.
6. Click OK to save changes. If the message "Configuration is
successfully done" appears on your screen, the update is
complete.
c
Caution:
Once you make changes to the Ethernet card, you must wait
until it registers the settings before turning off the printer.
7. Select the Connection Information in File Server Console's
MONITOR.NLM, and check if the print server name assigned to
the Ethernet card is logged in to the Active Connections list. It
takes up to five minutes to complete this.

Using the Ethernet card in Remote Printer mode

The following sections describe how to configure the Ethernet card
in Remote Printer mode.
Creating print queues in a file server
1. From any NetWare client, log in to the network with supervisor
privileges.
Using the Ethernet Card with NetWare 4-9