Initializing The Ethernet Card - Epson C823642 - Enet Print Server Type B Multi Protocol 10/100BTX Administrator's Manual

c
Caution:
After turning off the printer, wait until the status lights go out
before turning it back on; otherwise, the Ethernet card may not
reset correctly.
Wait until the status lights go out before pulling the card out of
the printer; otherwise, the Ethernet card may not reset correctly.
Note:
If the printer does not print the status sheet, first make sure that the
printer is online, then wait a minute. If it still does not print the
status sheet, turn off the printer and wait until the status lights go
out. Then turn it on again and retry the status sheet.
Some printers take more than 30 seconds to initialize the card.

Initializing the Ethernet Card

You must initialize the Ethernet card under the following
circumstances:
If you move the card to another printer
When there is an error communicating with the Ethernet card
Note:
You can also initialize the Ethernet card using EPSON Net!2. See
Chapter 10 for more information.
Follow these steps to initialize the Ethernet card:
1. Turn off the printer.
It will take several seconds for the Ethernet card to power down.
Wait until the status lights on the card go out before continuing
with step 2.
1-6 Getting Started