Configuring The Ethernet Card Using Epson Net!2 For Macintosh - Epson C823642 - Enet Print Server Type B Multi Protocol 10/100BTX Administrator's Manual

Configuring the Ethernet Card Using EPSON Net!2 for
Macintosh
Use EPSON Net!2 for Macintosh to configure the Ethernet card as
described below.
c
Caution:
Once you make changes to the Ethernet card using EPSON Net!2,
wait until it registers the settings before turning off or sending data
to the printer.
1. Make AppleTalk active in the Chooser.
2. Connect the Ethernet card to the network and turn on the
printer.
From your hard disk, double-click the EPSON Net!2 icon.
3.
4. Highlight the printer you want to configure from the list and
click Configuration.
Note:
If you have connected more than one printer with the same type of
Ethernet card to the network, you can distinguish the cards by
their MAC (Media Access Control) addresses. To view a card's
MAC address, press the status sheet button on the card for three
seconds. See Chapter 1 for details.
If the IP address is set to the default IP address, the printer model
might not appear.
Using the Ethernet Card with Macintosh 5-3