Setup Wizard Step 8 Of 10: Email Notification - NETGEAR UTM5EW-100NAS Appliance Reference Manual

Setup Wizard Step 8 of 10: Email Notification

Figure 2-14
Enter the settings as explained in
Note: After you have completed the steps in the Setup Wizard, you can make changes to
the administrator email notification settings by selecting Network Config > Email
Notification. For more information about these settings, see
"Configuring the E-mail Notification Server" on page
Table 2-8. Setup Wizard Step 8: Administrator Email Notification Settings
Setting
Administrator Email Notification Settings
Show as mail sender
SMTP server
This server requires
authentication
Send notifications to
Using the Setup Wizard to Provision the UTM in Your Network
ProSecure Unified Threat Management (UTM) Appliance Reference Manual
Table 2-8, then click Next to go the following screen.
Description (or Subfield and Description)
A descriptive name of the sender for e-mail identification purposes. For
example, enter UTM_Notifications@netgear.com.
The IP address and port number or Internet name and port number of your
ISP's outgoing e-mail SMTP server. The default port number is 25.
Note: If you leave this field blank, the UTM cannot send e-mail notifications.
If the SMTP server requires authentication, select the This server requires
authentication checkbox and enter the following settings:
User name The user name for SMTP server authentication.
Password The password for SMTP server authentication.
The email address to which the notifications should be sent. Typically, this is the
e-mail address of the administrator.
v1.0, January 2010
11-5.
2-23