Table of Contents
Advertisement
ProSecure Unified Threat Management (UTM) Appliance Reference Manual
Setup Wizard Step 9 of 10: Signatures & Engine
Figure 2-15
Enter the settings as explained in
screen.
Note: After you have completed the steps in the Setup Wizard, you can make changes to
the signatures and engine settings by selecting Administration > System Update
> Signatures and Engine. For more information about these settings, see
"Updating the Scan Signatures and Scan Engine Firmware" on page
2-24
Table 2-9 on page
2-25, then click Next to go the following
Using the Setup Wizard to Provision the UTM in Your Network
v1.0, January 2010
10-21.
Advertisement
Table of Contents
Troubleshooting
