NETGEAR UTM5EW-100NAS Appliance Reference Manual page 223

3. Select the radio buttons and complete the fields and as explained
Table 7-3. (IPsec) VPN Wizard Settings for a Client-to-Gateway Tunnel
Setting
About VPN Wizard
This VPN tunnel will connect
to the following peers
Connection Name and Remote IP Type
What is the new Connection
Name?
What is the pre-shared key?
This VPN tunnel will use
following local WAN Interface
(dual-WAN port models only)
End Point Information
What is the Remote Identifier
Information?
What is the Local Identifier
Information?
Secure Connection Remote Accessibility
What is the remote LAN IP
Address?
What is the remote LAN
Subnet Mask?
a. Both local and remote endpoints should be defined as either FQDNs or IP addresses. A combination of an IP address and
a FQDN is not supported.
.
Virtual Private Networking Using IPsec Connections
ProSecure Unified Threat Management (UTM) Appliance Reference Manual
Description (or Subfield and Description)
Select the VPN Client radio button. The default remote FQDN
(utm_remote.com) and the default local FQDN (utm_local.com) appear
in the End Point Information section of the screen.
Enter a descriptive name for the connection. This name is used to help
you to manage the VPN settings; the name is not supplied to the
remote VPN endpoint.
Enter a pre-shared key. The key must be entered both here and on the
remote VPN gateway, or the remote VPN client. This key must have a
minimum length of 8 characters and should not exceed 49 characters.
For the dual-WAN port models only, select one of the two radio buttons
(WAN1 or WAN2) to specify which local WAN interface the VPN tunnel
uses as the local endpoint.
Note: If a dual-WAN port model is configured to function in WAN auto-
rollover mode, after completing the wizard, you must manually update
the VPN policy to enable VPN rollover. For more information, see
"Manually Adding or Editing a VPN Policy" on page
a
When you select the Client radio button in the About VPN Wizard
section of the screen, the default remote FQDN (utm_remote.com) is
automatically entered. Use the default remote FQDN or enter another
FQDN.
When you select the Client radio button in the About VPN Wizard
section of the screen, the default local FQDN (utm_local.com) is
automatically entered. Use the default local FQDN or enter another
FQDN.
These fields are masked out for VPN client connections.
v1.0, January 2010
Table 7-3.
7-33.
7-11