NETGEAR UTM5EW-100NAS Appliance Reference Manual page 260

ProSecure Unified Threat Management (UTM) Appliance Reference Manual
8. On the Add IKE Policy screen, complete the fields, select the radio buttons, and make your
selections from the pull-down menus as explained
Note: The settings that are explained in
Config configuration.
policy settings.
Table 7-16. Add IKE Policy Settings for a Mode Config Configuration
Item
Mode Config Record
Do you want to use
Mode Config Record?
General
Policy Name
Direction / Type
Exchange Mode
Local
Select Local Gateway
(dual-WAN port
models only)
Identifier Type
7-48
Table 7-10 on page 7-27
Description (or Subfield and Description)
Select the Yes radio button.
Note: Because Mode Config functions only in Aggressive Mode, selecting the
Yes radio button sets the tunnel exchange mode to Aggressive mode and
disables the Main mode. Mode Config also requires that both the local and
remote ends are defined by their FQDNs.
Select Mode From the pull-down menu, select the Mode Config record
Config Record that you created in
using NA Sales.
A descriptive name of the IKE policy for identification and management
purposes.
Note: The name is not supplied to the remote VPN endpoint.
Responder is automatically selected when you select the Mode Config record
(see above). This ensures that the UTM responds to an IKE request from the
remote endpoint but does not initiate one.
Aggressive Mode is automatically selected when you select the Mode Config
record (see above).
For the dual-WAN port models only, select a radio button to specify the WAN1
or WAN2 interface.
From the pull-down menu, select FQDN.
Note: Mode Config requires that the UTM (that is, the local end) is defined by a
FQDN.
Identifier Enter a FQDN for the UTM. In this example, we are using
utm25_local.com.
Virtual Private Networking Using IPsec Connections
v1.0, January 2010
Table 7-16.
Table 7-16 are specifically for a Mode
explains the general IKE
step 5 above. In this example, we are