Setup Wizard Step 6 Of 11: Email Notification Server Settings - NETGEAR STM150 Appliance Reference Manual

ProSecure Web/Email Security Threat Management (STM) Appliance Reference Manual

Setup Wizard Step 6 of 11: Email Notification Server Settings

Figure 2-15
Enter the settings as explained in
screen.
Note: After you have completed the steps in the Setup Wizard, you can make changes to
the administrator email notification settings by selecting Global Settings > Email
Notification server. For more information about these settings, see
the E-mail Notification Server" on page
Table 2-5. Setup Wizard Step 6: Email Notification Server Settings
Setting
Email Notification Server Settings
Show as Mail sender
Send Notifications to
SMTP server
2-20
Table 2-5 on page
Description (or Subfield and Description)
A descriptive name of the sender for e-mail identification purposes. For
example, enter stm600notification@netgear.com.
The email address to which the notifications should be sent. Typically, this is the
e-mail address of a user with administrative privileges.
The IP address and port number or Internet name and port number of your
ISP's outgoing e-mail SMTP server. The default port number is 25.
Note: If you leave this field blank, the STM cannot send e-mail notifications.
Using the Setup Wizard to Provision the STM in Your Network
v1.0, September 2009
2-20, then click Next to go the following
6-2.
"Configuring