NETGEAR UTM5EW-100NAS Appliance Reference Manual page 29

Note: Figure 1-2
contain the left WAN port that is shown in
any Active WAN LEDs.
The function of each LED is described in
Table 1-2. LED Descriptions
Object Activity
Power On (Green)
Off
Test On (Amber) during
startup.
On (Amber) during
any other time
Blinking (Amber)
Off
LAN Ports
Left LED Off
On (Green)
Blink (Green)
Right LED Off
On (Amber)
On (Green)
DMZ LED Off
On (Green)
WAN Ports
Left LED Off
On (Green)
Blink (Green)
Right LED Off
On (Amber)
On (Green)
Introduction
ProSecure Unified Threat Management (UTM) Appliance Reference Manual
shows a dual-WAN port model (the UTM25). Single-WAN port models
Table
Description
Power is supplied to the UTM.
Power is not supplied to the UTM.
Test mode: The UTM is initializing. After approximately 2 minutes,
when the UTM has completed its initialization, the Test LED goes off.
The initialization has failed or a hardware failure has occurred.
Writing to flash memory (during upgrading or resetting to defaults).
The system has booted successfully.
The LAN port has no link.
The LAN port has detected a link with a connected Ethernet device.
Data is being transmitted or received by the LAN port.
The LAN port is operating at 10 Mbps.
The LAN port is operating at 100 Mbps.
The LAN port is operating at 1000 Mbps.
Port 4 is operating as a normal LAN port.
Port 4 is operating as a dedicated hardware DMZ port.
The WAN port has no physical link, that is, no Ethernet cable is
plugged into the UTM.
The WAN port has a valid connection with a device that provides an
Internet connection.
Data is being transmitted or received by the WAN port.
The WAN port is operating at 10 Mbps.
The WAN port is operating at 100 Mbps.
The WAN port is operating at 1000 Mbps.
v1.0, January 2010
Figure 1-2 but no right WAN port nor
1-2.
1-11