NETGEAR UTM5EW-100NAS Appliance Reference Manual page 366

ProSecure Unified Threat Management (UTM) Appliance Reference Manual
Table 11-1. WAN Traffic Meter Settings (continued)
Setting
When Limit is reached
Block traffic
Send e-mail alert
3. Click Apply to save your settings.
4. For the dual-WAN port models only, click the WAN2 Traffic Meter submenu tab. The WAN2
Traffic Meter screen displays. This screen is identical to the WAN1 Traffic Meter screen (see
Figure 11-1 on page
5. For the dual-WAN port models only, repeat
To display a report of the Internet traffic by type, click the Traffic by Protocol option arrow at the
top right of the WAN1 Traffic Meter or WAN2 Traffic Meter screen (dual-WAN port models), or at
the top right of the WAN Traffic Meter screen (single-WAN port models). The Traffic by Protocol
screen appears in a popup window. The incoming and outgoing volume of traffic for each protocol
and the total volume of traffic is displayed. Traffic counters are updated in MBs; the counter starts
only when traffic passed is at least 1 MB. In addition, the popup screen displays the traffic meter's
start end dates.
Figure 11-2
11-4
Description (or Subfield and Description)
Select one of the following radio buttons to specify what action the UTM performs
when the traffic limit has been reached:
• Block All Traffic. All incoming and outgoing Internet and e-mail traffic is
blocked.
• Block All Traffic Except E-Mail. All incoming and outgoing Internet traffic is
blocked but incoming and outgoing e-mail traffic is still allowed.
An e-mail alert is sent when traffic is blocked. Ensure that e-mailing of logs is
enabled on the Email and Syslog screen (see
System, E-mail, and Syslog Logs" on page
11-2).
v1.0, January 2010
"Configuring and Activating
11-6).
step 2 and step 3 for the WAN2 interface.
Monitoring System Access and Performance