NETGEAR UTM5EW-100NAS Appliance Reference Manual page 78

ProSecure Unified Threat Management (UTM) Appliance Reference Manual
Table 3-6. Protocol Binding Settings (Dual-WAN Port Models Only) (continued)
Setting
Source Network
(continued)
Destination
Network
b. Click the Add table button in the rightmost column to add the protocol binding rule to the
Protocol Binding table. The rule is automatically enabled, which is indicated by the "!"
status icon that displays a green circle.
c. Repeat step a
Binding table.
d. If not all table entries are enabled, select the table entries that you want to enable, or click
the Select All table button. Then, click the Enable table button.
e. Open the WAN2 Protocol Bindings screen and repeat
bindings for the WAN2 port.
f. Return to the WAN Mode screen by selecting Network Config > WAN Settings from the
menu and clicking the WAN Mode tab.
4. Click Apply to save your settings.
3-16
Description (or Subfield and Description)
Group 1–Group 8 If this option is selected, the rule is applied to the devices
that are assigned to the selected group.
Note: You may also assign a customized name to a group
(see
page
The destination network settings determine which Internet locations (based on
their IP address) are covered by the rule. Select one of the following options
from the pull-down menu:
Any All Internet IP address.
Single address In the Start Address field, enter the IP address that is
covered by the rule.
Address range In the Start Address field and End Address field, enter the
IP addresses for the range that is covered by the rule.
and step b for each protocol binding rule that you want to add to the Protocol
v1.0, January 2010
"Changing Group Names in the Network Database" on
4-16).
step a through
Manually Configuring Internet and WAN Settings
step d to set protocol