Table of Contents
Advertisement
Table 4-5. RIP Configuration Settings (continued)
Setting
Authentication for
RIP-2B/2M required?
(continued)
4. Click Apply to save your settings.
Static Route Example
In this example, we assume the following:
•
The UTM's primary Internet access is through a cable modem to an ISP.
•
The UTM is on a local LAN with IP address is 192.168.1.100.
•
The UTM connects to a remote network where you must access a device.
•
The LAN IP address of the remote network is 134.177.0.0.
When you first configured the UTM, two implicit static routes were created:
•
A default static route was created with your ISP as the gateway.
•
A second static route was created to the local LAN for all 192.168.1.x addresses.
With this configuration, if you attempt to access a device on the 134.177.0.0 remote network, the
UTM forwards your request to the ISP. In turn, the ISP forwards your request to the remote
network, where the request is likely to be denied by the remote network's firewall.
In this case you must define a static route, informing the UTM that the 134.177.0.0 IP address
should be accessed through the local LAN IP address (192.168.1.100).
The static route on the UTM must be defined as follows:
•
The destination IP address and IP subnet mask must specify that the static route applies to all
134.177.x.x IP addresses.
•
The gateway IP address must specify that all traffic for the 134.177.x.x IP addresses should be
forwarded to the local LAN IP address (192.168.1.100).
•
A metric value of 1 should work since the UTM is on the local LAN.
•
The static route can be made private only as a precautionary security measure in case RIP is
activated.
LAN Configuration
ProSecure Unified Threat Management (UTM) Appliance Reference Manual
Description (or Subfield and Description)
Not Valid Before
Not Valid After
v1.0, January 2010
The beginning of the lifetime of the MD5 key. Enter the
month, date, year, hour, minute, and second. Before this
date and time, the MD5 key is not valid.
The end of the lifetime of the MD5 key. Enter the month,
date, year, hour, minute, and second. After this date and
time, the MD5 key is no longer valid.
4-27
Advertisement
Table of Contents
Troubleshooting
