Table of Contents
Advertisement
Chapter 5 Running Diagnostic Programs
Running the Barcode Scanner Test
Figure 49 Diag:
Barcode Screen
78
Tandberg Data
6 Press the
and
Up
7 Press
to move the highlight to the next number.
Left
8 Repeat steps
6
and
number is displayed.
Setting the cycle count to
Note:
continuously.
9 Press
until the cursor is all the way to the right and the
Right
button appears.
10 Press
to set the cycle count, or press
Select
screen without running the
Diags: General
The test starts and the GUI displays a
stops automatically after completing the selected number of cycles.
When the test is complete, the GUI displays a screen indicating the
test status.
To abort the test before it completes the selected number of cycles,
press
.
Stop
11 Press
to return to the
Back
Tandberg Data M-Series User's Guide
buttons to change the highlighted number.
Down
7
as necessary until the desired cycle count
0000
Running Diag
Diags: General
causes the test to run
Select
to return to the
Cancel
test.
Barcode Scanner
screen. The test
screen.
Advertisement
Table of Contents
Need help?
Do you have a question about the MSERIES USER and is the answer not in the manual?
Questions and answers