Figure 55 Diag: Move Location Screen - Tandberg Data MSERIES USER User Manual

Chapter 5 Running Diagnostic Programs
Running the Move Location Test
Figure 55 Diag: Move
Location Screen
84
The GUI displays the
to set the cycle count (see
highlighted.
Tandberg Data
8 Press the and
Up
9 Press to move the highlight to the next number.
Left
10 Repeat steps 8 and
number is displayed.
Setting the cycle count to
Note:
continuously.
11 Press until the cursor is all the way to the right and the
Right
button appears.
12 Press to set the cycle count, or press
Select
screen without running the
Diags: General
The test starts and the GUI displays a
stops automatically after completing the selected number of cycles.
When the test is complete, the GUI displays a screen indicating the
test status.
To abort the test before it completes the selected number of cycles,
press .
Stop
Tandberg Data M-Series User's Guide
Diag: Move Location
figure 55). The rightmost number is
buttons to change the highlighted number.
Down
9 as necessary until the desired cycle count
0000
Running Diag
screen, which prompts you
causes the test to run
Select
to return to the
Cancel
test.
Move Location
screen. The test