Changing The Auto-Clean Setting - Tandberg Data MSERIES USER User Manual

Chapter 3 Changing the Library Configuration

Changing the Auto-Clean Setting

Changing the Auto-Clean Setting
64
To select the
Import/Export
Changing this setting may cause the host(s) to fail to
Caution:
recognize the library. If you change this setting, be aware
that you will have to reconfigure your backup software for
the new library configuration.
1 Access the
Configuration
Screen on page 49).
2 Press the or
Up Down
3 Press .
Select
4 Use the or
Up Down
The available settings are
libraries), and
MAP
5 Press .
Select
To return to the
Configuration
setting, press
Cancel
6 Press to return to the main screen.
Main
This setting takes effect when you reboot the library.
Note:
To enable or disable
Auto-Clean
1 Access the
Configuration
Screen on page 49).
2 Press the or
Up Down
3 Press .
Select
4 Use the or
Up Down
The available settings are
5 Press .
Select
Tandberg Data M-Series User's Guide
setting:
screen (see Accessing the Configuration
buttons until
Import/Export
buttons to select the desired
, ,
None 1-Slot 10-Slot
(default).
screen without changing the option
.
:
screen (see Accessing the Configuration
buttons until
Auto-Clean
buttons to select the desired
or
Enabled Disabled
is highlighted.
setting.
Import/Export
(or in LTO
12-Slot
is highlighted.
setting.
Auto-Clean
(default).
3