Changing The Off-Line Time Setting - Tandberg Data MSERIES USER User Manual

Changing the Off-Line Time Setting

4 Use the or
Up Down
The available settings are
5 Press .
Select
To return to the
Configuration
setting, press
Cancel
6 Press to return to the main screen.
Main
When you access the
NOT READY and will not respond to any SCSI commands issued. If you
leave the library unattended in menu mode, the library goes back to a
READY state after a pre-set time-out, controlled by the
option. You can set this time-out to any value from 1 to 99 minutes, or
turn it off.
To set the
Off-Line Time
1 Access the
Configuration
Screen on page 49).
2 Press the or
Up Down
3 Press .
Select
4 Use the or
Up Down
The available settings are
5 Press .
Select
To return to the
Configuration
setting, press
Cancel
6 Press to return to the main screen.
Main
Tandberg Data M-Series User's Guide
Chapter 3 Changing the Library Configuration
Changing the Off-Line Time Setting
buttons to select the desired
(default) and
Enabled
screen without changing the option
.
screen using the GUI, the library becomes
Menu
:
screen (see Accessing the Configuration
buttons until
Off-Line Time
buttons to select the desired
through
1 99
screen without changing the option
.
Illumination
.
Disabled
Off-Line Time
is highlighted.
Off-Line Time
and (default).
Disabled
setting.
3
setting.
59