Visual Inspection Of Dlttape Cartridges; When To Visually Inspect A Dlttape Cartridge - Tandberg Data MSERIES USER User Manual

Appendix C DLTtape Cartridge Maintenance

Visual Inspection of DLTtape Cartridges

Visual Inspection of DLTtape Cartridges
When To Visually
Inspect a DLTtape
3
Cartridge
160
• Never apply adhesive labels or POST-IT notes to the top, side, or
bottom of your DLTtape cartridge. Only use the user slide- in type
label provided with each cartridge and slide it over the label slot on
the cartridge.
• Do not carry cartridges loosely in a box or any other container.
Allowing cartridges to bang together exposes them to unnecessary
physical shock.
• Do not touch or allow direct contact with tape or tape leader. Dust or
natural skin oils can contaminate the tape and impact tape
performance.
• Do not expose the tape cartridge to moisture or direct sunlight.
• Do not insert a dropped or damaged cartridge into a DLTtape drive
without, at the very least, a thorough visual inspection (see
Inspection of DLTtape
dislodged, loosened, or damaged internal components.
It is important to visually inspect a DLTtape cartridge under the
following circumstances:
• Whenever you change or load a new tape cartridge
• If the tape cartridge has been dropped or subjected to a physical
shock
• If a DLTtape drive becomes inoperable after loading the tape
cartridge
• If you receive a shipment of tape cartridges that shows any sign of
being damaged
Tandberg Data M-Series User's Guide
Cartridges). A dropped cartridge may have
Visual
3