Changing The Barcode Scanner Setting; Changing The Baud Rate Setting - Tandberg Data MSERIES USER User Manual

Chapter 3 Changing the Library Configuration

Changing the Barcode Scanner Setting

Changing the Barcode Scanner Setting

Changing the Baud Rate Setting

60
The
Barcode Scanner
enabled or disabled. When the scanner is enabled, the library attempts to
detect a bar code on all tape cartridge labels. If the correct bar code labels
are not used, or if some cartridges are not labeled, scanning time may be
greatly increased. Therefore, it is recommended that you disable the
option if you do not intend to use compatible bar code
Barcode Scanner
labels.
To enable or disable the
1 Access the
Configuration
Screen on page 49).
2 Press the or
Up Down
3 Press .
Select
4 Use the or
Up Down
setting. The available settings are
5 Press .
Select
To return to the
Configuration
setting, press
Cancel
6 Press to return to the main screen.
Main
This setting takes effect when you reboot the library.
Note:
The option controls the baud rate setting of the serial
Baud Rate
diagnostics port. You can set the baud rate to any standard rate between
1200 baud and 38400 baud.
To set the :
Baud Rate
1 Access the
Configuration
Screen on page 49).
Tandberg Data M-Series User's Guide
option controls whether the bar code scanner is
option:
Barcode Scanner
screen (see Accessing the Configuration
buttons until
Barcode Scanner
buttons to select the desired
Enabled
screen without changing the option
.
screen (see Accessing the Configuration
is highlighted.
Barcode Scanner
(default) and
Disabled
3
.
3