Figure 38 M2500 Drive Numbering - Tandberg Data MSERIES USER User Manual

Chapter 3 Changing the Library Configuration
Changing a Tape Drive ID
Figure 38 M2500
Drive Numbering
52
Figure 38 illustrates the drive numbering scheme for the M2500.
To change a tape drive SCSI ID:
1 Access the
Configuration
Screen).
2 Press the or
Up Down
) is highlighted.
Drive 1 ID
3 Press .
Select
4 Use the or
Up Down
settings are through
0
Set the drive SCSI ID to
Caution:
installed in the library.
Tandberg Data M-Series User's Guide
screen (see Accessing the Configuration
buttons until the desired drive ID (for example,
buttons to select the desired SCSI ID. Available
through and
9, A F,
Disabled
Drive 1 (default
SCSI ID = 1)
Drive 2 (default
SCSI ID = 2)
Drive 3 (default
SCSI ID = 3)
Drive 4 (default
SCSI ID = 4)
Drive 5 (default
SCSI ID = 15)
Drive 6 (default
SCSI ID = 14)
.
Disabled
only if the drive is not