Attaching An Alarm Profile To A Specific Port; Enabling Snmp Traps - Cisco IE-3000-8TC Software Configuration Manual

Chapter 3 Configuring Cisco IE 3000 Switch Alarms
Table 3-4
alarms, see the
Table 3-4
AlarmList ID Alarm Description
1
2
3
4

Attaching an Alarm Profile to a Specific Port

In interface configuration mode, you can use the alarm-profile command to attach an alarm profile to a
specific port.
Beginning in privileged EXEC mode, follow these steps to attach an alarm profile to a port:
Command
Step 1
configure terminal
Step 2 interface port interface
Step 3 alarm-profile name
Step 4 end
Step 5 show alarm profile
Step 6
copy running-config startup-config (Optional) Save your entries in the configuration file.
To detach an alarm profile from a specific port, use the no alarm-profile name interface configuration
command.
This example attaches an alarm profile named fastE to a port.
Switch(config)# interface fastethernet 1/2
Switch(config-if)# alarm profile fastE
This example detaches an alarm profile named fastE from a port.
Switch(config)# interface fastethernet 1/2
Switch(config-if)# no alarm profile fastE

Enabling SNMP Traps

Use the snmp-server enable traps alarms global configuration command to enable the switch to send
alarm traps.
Note Before using alarm profiles to set the switch to send SNMP alarm trap notifications to an SNMP server,
you must first enable SNMP by using the snmp-server enable traps alarms global configuration
command.
OL-13018-03
lists the alarmList IDs and their corresponding alarm definitions. For a description of these
"Port Status Monitoring Alarms" section on page
AlarmList ID Number Alarm Descriptions
Link fault
Port not forwarding
Port not operating
FCS error rate exceeds threshold
Purpose
Enter global configuration mode.
Enter the number of the switch port to be configured, and the switch enters
interface configuration mode.
Attach the specified profile to the interface.
Return to privileged EXEC mode.
Verify the configuration.
Configuring IE 3000 Switch Alarms
3-2.
Cisco IE 3000 Switch Software Configuration Guide
3-11