Displaying Etherchannel, Pagp, And Lacp Status - Cisco IE-3000-8TC Software Configuration Manual

Chapter 38 Configuring EtherChannels and Link-State Tracking
If LACP is not able to aggregate all the ports that are compatible (for example, the remote system might
Note
have more restrictive hardware limitations), all the ports that cannot be actively included in the
EtherChannel are put in the hot-standby state and are used only if one of the channeled ports fails.
Beginning in privileged EXEC mode, follow these steps to configure the LACP port priority. This
procedure is optional.
Command
Step 1 configure terminal
Step 2 interface interface-id
Step 3 lacp port-priority priority
Step 4
end
Step 5
show running-config
or
show lacp [channel-group-number]
internal
Step 6 copy running-config startup-config
To return the LACP port priority to the default value, use the no lacp port-priority interface
configuration command.

Displaying EtherChannel, PAgP, and LACP Status

To display EtherChannel, PAgP, and LACP status information, use the privileged EXEC commands
described in
Table 38-4 Commands for Displaying EtherChannel, PAgP , and LACP Status
Command
show etherchannel [channel-group-number {detail |
port | port-channel | protocol | summary}] {detail |
load-balance | port | port-channel | protocol |
summary}
show pagp [channel-group-number] {counters |
internal | neighbor}
show pagp [channel-group-number] dual-active
show lacp [channel-group-number] {counters |
internal | neighbor}
OL-13018-03
Purpose
Enter global configuration mode.
Specify the port to be configured, and enter interface configuration
mode.
Configure the LACP port priority.
For priority, the range is 1 to 65535. The default is 32768. The lower the
value, the more likely that the port will be used for LACP transmission.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Table 38-4:
Description
Displays EtherChannel information in a brief, detailed, and
one-line summary form. Also displays the load-balance or
frame-distribution scheme, port, port-channel, and protocol
information.
Displays PAgP information such as traffic information, the
internal PAgP configuration, and neighbor information.
Displays the dual-active detection status.
Displays LACP information such as traffic information, the
internal LACP configuration, and neighbor information.
Displaying EtherChannel, PAgP, and LACP Status
Cisco IE 3000 Switch Software Configuration Guide
38-17