Appendix B
Working with the Cisco IOS File System, Configuration Files, and Software Images
Table B-3
info File Description (continued)
Field
total_image_file_size
image_feature
image_min_dram
image_family
Copying Image Files By Using TFTP
You can download a switch image from a TFTP server or upload the image from the switch to a TFTP
server.
You download a switch image file from a server to upgrade the switch software. You can overwrite the
current image with the new one or keep the current image after a download.
You upload a switch image file to a server for backup purposes; this uploaded image can be used for
future downloads to the same or another switch of the same type.
Instead of using the copy privileged EXEC command or the archive tar privileged EXEC command, we
Note
recommend using the archive download-sw and archive upload-sw privileged EXEC commands to
download and upload software image files.
These sections contain this configuration information:
•
•
•
Preparing to Download or Upload an Image File By Using TFTP
Before you begin downloading or uploading an image file by using TFTP, do these tasks:
•
OL-13018-03
Description
Specifies the size of all the images (the Cisco IOS image and the web management files) in the
tar file, which is an approximate measure of how much flash memory is required to hold them
Describes the core functionality of the image
Specifies the minimum amount of DRAM needed to run this image
Describes the family of products on which the software can be installed
Preparing to Download or Upload an Image File By Using TFTP, page B-25
Downloading an Image File By Using TFTP, page B-26
Uploading an Image File By Using TFTP, page B-28
Ensure that the workstation acting as the TFTP server is properly configured. On a Sun workstation,
make sure that the /etc/inetd.conf file contains this line:
tftp dgram udp wait root /usr/etc/in.tftpd in.tftpd -p -s /tftpboot
Make sure that the /etc/services file contains this line:
tftp 69/udp
You must restart the inetd daemon after modifying the /etc/inetd.conf and /etc/services files.
Note
To restart the daemon, either stop the inetd process and restart it, or enter a fastboot
command (on the SunOS 4.x) or a reboot command (on Solaris 2.x or SunOS 5.x). For more
information on the TFTP daemon, see the documentation for your workstation.
Working with Software Images
Cisco IE 3000 Switch Software Configuration Guide
B-25