Cisco IE-3000-8TC Software Configuration Manual page 314

Configuring Smartports Macros
Command
Step 9
show running-config interface
interface-id
Step 10
copy running-config startup-config
You can only delete a global macro-applied configuration on a switch by entering the no version of each
command in the macro. You can delete a macro-applied configuration on a port by entering the default
interface interface-id interface configuration command.
This example shows how to display the cisco-ie-desktop macro, how to apply the macro and to set the
access VLAN ID to 25 on an interface:
Switch# show parser macro name cisco-ie-desktop
--------------------------------------------------------------
Macro name : cisco-ie-desktop
Macro type : default interface
# macro keywords $access_vlan
#macro name cisco-ie-desktop
switchport mode access
switchport access vlan $access_vlan
switchport port-security
switchport port-security maximum 1
switchport port-security aging time 2
switchport port-security violation restrict
switchport port-security aging type inactivity
spanning-tree portfast
spanning-tree bpduguard enable
no macro description
macro description cisco-ie-desktop
--------------------------------------------------------------
Switch#
Switch# configure terminal
Switch(config)# interface gigabitethernet1/4
Switch(config-if)# macro apply cisco-ie-desktop $AVID 25
This example shows how to display the cisco-ethernetip macro and how to apply it to an interface:
Switch# show parser macro name cisco-ethernetip
Macro name :
Macro type : default interface
#macro name cisco-ethernetip
#macro keywords $access_vlan
#macro description cisco-ethernetip
switchport host
switchport access vlan $access_vlan
storm-control broadcast level 3.00 1.00
service-policy input CIP-Traffic
#service-policy input 1588
Switch# configure terminal
Switch(config)# interface fastethernet 1/1
Switch(config-if)# macro apply cisco-ethernetip $access_vlan 1
switchport mode will be set to access
spanning-tree portfast will be enabled
channel group will be disabled
Cisco IE 3000 Switch Software Configuration Guide
14-4
Purpose
Verify that the macro is applied to an interface.
(Optional) Save your entries in the configuration file.
cisco-ie-global
Chapter 14 Configuring Smartports Macros
OL-13018-03