Cisco IE-3000-8TC Software Configuration Manual page 119

Chapter 5 Configuring Cisco EnergyWise
Figure 5-5
192.168.1.2
On Switch 1, to prevent a disjointed domain, manually assign Switch 2 as a static neighbor or the reverse.
Switch(config)# energywise neighbor 192.168.2.2 43440
Switch 1 discovers Switch 3 as a neighbor because they are in the same LAN.
On Switch 1, verify neighbor discovery.
Switch# show energywise neighbors
Capability Codes: R-Router, T-Trans Bridge, B-Source Route Bridge
Id
--
6
9
Switch 1 uses both static and dynamic protocols to detect neighbors.
Verify that switches are in the same domain:
Switch# energywise query name * collect usage
EnergyWise query, timeout is 3 seconds:
Host
----
192.168.1.2
192.168.40.2
192.168.40.2
192.168.50.2
192.168.50.2
Queried:
In a routed network, a switch port assigned to a VLAN can be connected to a router interface. The IP
address of the VLAN SVI is 192.168.1.2, and the IP address of the router interface is 192.168.1.1.
Configure the domain:
Switch(config)# energywise domain cisco secret 0 cisco protocol udp port 43440 ip
192.168.1.2
OL-13018-03
EnergyWise with IP Routing
LAN 10
Switch 1
Port 24
Switch 3
192.168.1.3
S-Switch, H-Host, I-IGMP, r-Repeater, P-Phone
Neighbor Name Ip:Port
------------- -------
Switch-2 192.168.2.2:43440
Switch-3 192.168.1.3:43440
Name
----
Switch-1
shipping.1
guest.1
shipping.2
lobby.1
72 Responded:
Router A
Port 1
Port 24
192.168.1.1/24 192.168.2.1/24
Prot
----
static
cdp
Usage
-----
96.0 (W)
6.3 (W)
10.3 (W)
8.5 (W)
10.3 (W)
72 Time: 0.65 second
Cisco IE 3000 Switch Software Configuration Guide
Additional Information
LAN 20
Switch 2
Port 1
192.168.2.2
Capability
----------
S I
S I
5-19