Displaying Rmon Status - Cisco IE-3000-8TC Software Configuration Manual

Displaying RMON Status

Command
Step 3
rmon collection stats index [owner ownername] Enable RMON statistic collection on the interface.
Step 4
end
Step 5 show running-config
Step 6 show rmon statistics
Step 7 copy running-config startup-config
To disable the collection of group Ethernet statistics, use the no rmon collection stats index interface
configuration command.
This example shows how to collect RMON statistics for the owner root:
Switch(config)# interface gigabitethernet1/1
Switch(config-if)# rmon collection stats 2 owner root
Displaying RMON Status
To display the RMON status, use one or more of the privileged EXEC commands in
Table 31-1
Command
show rmon
show rmon alarms
show rmon events
show rmon history
show rmon statistics
For information about the fields in these displays, see the "System Management Commands" section in
the Cisco IOS Configuration Fundamentals Command Reference, Release 12.2 from the Cisco.com page
under Documentation > Cisco IOS Software > 12.2 Mainline > Command References.
Cisco IE 3000 Switch Software Configuration Guide
31-6
Purpose
• For index, specify the RMON group of statistics. The range
is from 1 to 65535.
• (Optional) For owner ownername, enter the name of the
owner of the RMON group of statistics.
Return to privileged EXEC mode.
Verify your entries.
Display the contents of the switch statistics table.
(Optional) Save your entries in the configuration file.
Commands for Displaying RMON Status
Purpose
Displays general RMON statistics.
Displays the RMON alarm table.
Displays the RMON event table.
Displays the RMON history table.
Displays the RMON statistics table.
Chapter 31 Configuring RMON
Table 31-1:
OL-13018-03