Chapter 18
Configuring STP
Configuring Spanning-Tree Features
•
•
•
•
•
•
•
•
•
•
Default Spanning-Tree Configuration
Table 18-3
Table 18-3
Default Spanning-Tree Configuration
Feature
Enable state
Spanning-tree mode
Switch priority
Spanning-tree port priority (configurable on a per-interface basis)
Spanning-tree port cost (configurable on a per-interface basis)
Spanning-tree VLAN port priority (configurable on a per-VLAN basis)
Spanning-tree VLAN port cost (configurable on a per-VLAN basis)
Spanning-tree timers
OL-13018-03
Default Spanning-Tree Configuration, page 18-11
Spanning-Tree Configuration Guidelines, page 18-12
Changing the Spanning-Tree Mode., page 18-13
Disabling Spanning Tree, page 18-14
Configuring the Root Switch, page 18-14
Configuring a Secondary Root Switch, page 18-16
Configuring Port Priority, page 18-16
Configuring Path Cost, page 18-18
Configuring the Switch Priority of a VLAN, page 18-19
Configuring Spanning-Tree Timers, page 18-20
shows the default spanning-tree configuration.
(required)
(optional)
(optional)
(optional)
(optional)
(optional)
(optional)
(optional)
Default Setting
Enabled on VLAN 1.
For more information, see the
Spanning-Tree Instances" section on
page
18-9.
PVST+. (Rapid PVST+ and MSTP are
disabled.)
32768.
128.
1000 Mb/s: 4.
100 Mb/s: 19.
10 Mb/s: 100.
128.
1000 Mb/s: 4.
100 Mb/s: 19.
10 Mb/s: 100.
Hello time: 2 seconds.
Forward-delay time: 15 seconds.
Maximum-aging time: 20 seconds.
Transmit hold count: 6 BPDUs
Cisco IE 3000 Switch Software Configuration Guide
Configuring Spanning-Tree Features
"Supported
18-11